Setting the High Limit Value in the MPX 2.0 Software for Real Time Data-Dependent Decision (RTD3)

日付: 09/24/2019
カテゴリー: MPX Software

0 投票
   印刷する    記事を評価する:

For research use only. Not for use in diagnostic procedures.


In the MPX software 2.0, the carryover detection feature requires that the values for the high or region height columns need to be defined for each component. These values are used to set the flag for the above upper concentration limit. 

The value for h = high can be determined from the upper limit of quantitation (ULOQ) for each analyte or from the maximum calibration value.
User-added image
User-added image

Region height is an optional limit that is set when a batch is submitted and this value can be used for flagging. The maximum value used here is 1e7.
User-added image