What Cable Should I Use To Connect PAL3 to an Agilent Pump when Using Analyst® Device Driver?

日付: 10/22/2020

0 投票
   印刷する    記事を評価する:

For research use only. Not for use in diagnostic procedures.


A sync cable, called the PAL connecting cable APG Remote, should be used to connect the PAL3 autosampler to an Agilent pump when both the devices are configured through the Analyst® Device Driver (ADD). The cable connects to the 15 pin INTERFACE connection on the back of the PAL3 autosampler and to the 9 pin REMOTE connection on the back of the Agilent pump.