Troubleshooting the ZenoTOF 7600 System: Tuning and Calibration

For research use only. Not for use in diagnostic procedures.

Answer

Before using the ZenoTOF 7600 system, users should run a system check to verify their instrument's performance. To confirm calibration, the MS Quick Status check can be run after ensuring that there is sufficient calibration solution in the bottle and that the selected polarity reflects the polarity that will be used in subsequent runs. After the check is complete, users can verify if the instrument passed or failed from the report output.

In the event that the MS Quick Status check fails, a link to a tuning and calibration troubleshooting guide is included here. Users can follow the steps in the flow chart to determine how to address calibration failures.